Skip to content
Bainbridge Island Drywall Repair

(360) 994-1576Open 7 days, 7am–9pmFix my wall →

Repair service

Post-remodel patching around Bainbridge Island

Post-remodel patching on Bainbridge Island usually starts with a wall full of other people's holes. Electricians fish wire, plumbers open a cavity to reach a valve, cabinet installers leave anchor holes and torn paper behind. The trades are done; the walls aren't.

This is usually a straightforward job. The openings are known, the framing is accessible, and nothing is wet. The work is mostly in backing each hole properly and blending it so the room reads as one surface.

Process

Trade order: when to bring us in

  1. After rough-inWiring, plumbing and ductwork are in place and nothing else needs to go through the wall.
  2. After inspectionIf the work needed a permit, openings stay open until the inspector has seen them.
  3. Before paintWe close and prime the patches; your painter or you take it from there.
  4. Before flooring and trimSanding dust and compound drips are easier to deal with before new floors go down.

Detail

Permits on the island: who signs off

Because the city's limits cover the whole island, building permits for remodels here go through the City of Bainbridge Island rather than Kitsap County. If your remodel needed one, the inspector may want to see the open framing or wiring before anything is closed. Ask your contractor whether that has happened before you book us.

Drywall patching by itself is cosmetic work. What we close is whatever the other trades leave open, once they're done with it.

At a glance

Typical openings: what each one takes

Most remodel holes fall into a few types.

Moved outlet or switch
Old box opening backed with a cleat, filled with a fitted piece, taped and coated. Simple.
Plumbing access cut
A square or rectangle, often a foot or more across. Backing on two sides, new board, tape and three coats.
Removed cabinet or shelving
Anchor holes, torn face paper, and sometimes a line where the old paint stopped. Torn paper gets sealed before any compound goes on.
Shifted door or opening
New framing, new board and long seams that need careful feathering. The biggest of the four.
Low-voltage runs
Small holes for network, speaker or camera cable. Often a single visit for the whole house.

Questions

Remodel patches: questions before booking

Should I save the pieces the electrician cut out?
Yes if they're clean. A cut-out piece can sometimes go back in with backing, which saves matching thickness.
Can you patch before my cabinet installer comes back?
We'd rather wait. A second round of anchor holes means a second visit for both of us.
Do you paint too?
We prime every patch. Full painting is usually better done by your painter or yourself once everything is closed.
How much of the wall gets touched?
Each patch is feathered a few inches past the opening. On smooth walls, wider.

Detail

Drying time: plan the schedule around it

Each coat of compound has to cure before the next goes on, and the island's wet season slows that cure. A batch of remodel patches is often three short visits over several days. Keeping the heat on in the house during that time makes a real difference.

If you're living in the house during the work, we keep it to one room at a time, mask the doorways and vacuum before leaving every day. Furniture needs a few feet of clearance from the wall. That's usually all the prep it takes.

Related

If a remodel uncovers an old leak stain, the water-damage repair page covers that. For rooms with plain walls, our notes on flat, untextured finishes apply.

We also take remodel work in several towns off the island. When the trades are out, book a look at the openings.

Next

Trades out, walls open: send the list

A quick photo of each opening and a count of how many there are is enough for us to plan the visits.