Skip to content
Bainbridge Island Drywall Repair

(360) 994-1576Open 7 days, 7am–9pmFix my wall →

Landlord guide

Rental turnover walls: a guide for Bainbridge Island landlords

Renting is a bigger part of the picture in Winslow than on the rest of the island. At the 2020 census, more than half of Winslow households lived in rental units, against about one in five across the whole island. If you own one of those units, you'll handle a lot of move-outs, and walls are where most of the visible wear shows.

This guide is about sorting that damage quickly and honestly, so you can fix what needs fixing without paying for what doesn't.

Walk-through

Walk-through: sorting move-out damage

Walk every room with good light and a roll of painter's tape. Mark each spot, then sort it into one of these.

Picture-hanger and anchor holes
Small. Fill, sand, spot-prime. Most landlords do these themselves, and that's the right call.
Doorknob hole
A hand-sized hole behind a door. Needs a backed patch, two or three coats. Fit a door stop afterward so it doesn't happen again.
Torn face paper
From tape, adhesive hooks or removed shelving. Seal the torn paper with primer before any compound, or it bubbles.
Dented outside corners
Furniture moving out. Small dents fill; crushed corner bead gets cut out and replaced.
Scuffs and marks
Not damage. Wash first; paint if washing doesn't do it.
Stains near windows or bathrooms
Check for moisture before painting. A damp spot needs its source found first.

Notes

Patch or paint: deciding wall by wall

Touch-up paint on a patched spot rarely disappears completely. The patch absorbs paint differently, and any sheen difference shows in daylight. If a wall has more than two or three repairs, plan to roll the whole wall, corner to corner. It's simpler than chasing flashing spots.

If a wall has one small patch and the existing paint is clean and fairly new, a careful spot-prime and touch-up may be enough. Keep a labeled can of every paint color used in each unit. That one habit saves more turnover time than anything else on this list.

Smooth walls are the exception. On a plain wall with eggshell paint, even a perfect patch can show under low sun. Our page on patching flat, untextured walls explains why.

Timeline

Scheduling: fitting repairs between tenants

  1. Day oneWalk-through, then patching. Every hole and crack gets its first coat.
  2. Day twoSecond coats, sanding on the first-day patches, spot-priming.
  3. Day threeFinal sand and prime. Painting can start that afternoon.
  4. After paintCleaning, then any flooring work last.

Notes

Wet-season turnovers: allow extra drying

Joint compound dries in air, and air on this island is damp for much of the year. The rainy stretch runs from about October into May, and an empty, unheated unit dries compound slowly. Keep the heat on during turnover, even with nobody living there. A day of heat before patching and during the work speeds every coat.

Unheated units in winter can also pick up condensation on outside walls, which shows as faint gray shadows or mildew spots near the floor or behind where furniture sat. Clean those, let the wall dry and seal it before painting.

Notes

Records: photos for the file

Photograph every wall at move-in and move-out, from the same spots, with the same light. Date the files. It keeps deposit conversations short and honest on both sides. Close-ups of each repair before and after patching help too.

If a tenant reported a leak or crack during the lease, keep that note with the photos. It helps separate wear from damage, and it tells the next person working on the wall where to look for moisture.

Notes

When to bring in help

Bring someone in when a turnover has bigger patches, ceiling stains, cracks that keep coming back, or simply too many holes for your timeline. Our recurring crack fixes and ceiling stain repairs cover the two most common callbacks. For anything you can do yourself, the notes above should be enough.